To examine the evolutions of defect check details structures and surface morphologies, retractions of the probe along Y direction to its initial height are conducted right after the completion of the two scratching stages. Figure 3 presents instantaneous defect structures and surface morphologies of the substrate after the completion of scratching and retraction for the two scratching depths. We note that the following observations are made based on not only the captured MD snapshots, but also the entire dynamic process provided by MD simulations: under the scratching depth D1, the substrate undergoes pure elastic deformation,

and there is no defect formed beneath the surface after the completion of the scratching, GSK872 datasheet as shown in Figure 3a. Accordingly, there is only one penetration impression formed on the surface shown in Figure 3e. Furthermore, Figure 3b,f demonstrates that the penetrated surface is fully recovered after the retraction, indicating that there is no permanent deformation that occurs within the substrate. Under the scratching

depth D2, however, it is seen from Figure 3c that the defect zone beneath the surface extends significantly along the scratching direction. Figure 3g shows that there is one scratching-induced impression of the groove formed on the surface, and Osimertinib price wear debris which accumulate on both sides of the groove is also observed. Although the penetrated surface undergoes tiny plastic recovery accompanied by the shrinking of the defect structures beneath the probe after the retraction, Figure 3d,h shows that both the defect structures, particularly those behind the probe, and the surface morphology are mainly unchanged. Furthermore, the height of wear debris increases slightly due to the annihilation of the dislocations at the surface [24]. Exoribonuclease Figure 3 Defect structures and surface morphologies after scratching and retraction under D1 and D2 (a,b,c,d). Defect structures after scratching and

retraction under the scratching depths D1 and D2, respectively. Atoms are colored according to their BAD values, and FCC atoms are not shown. (e,f,g,h) Surface morphologies after scratching and retraction under the scratching depths D1 and D2, respectively. Atoms are colored according to their heights in Y direction. The above analysis indicates that the minimum wear depth is closely associated with the initiation of plasticity. To reveal the specific defect structures formed at the early stage of plastic deformation, a dynamic inspection of the defect evolution in the regime II of Figure 2 is performed. Figure 4a shows that at the critical penetration depth of 0.72 nm a dislocation loop formed on one 111 slip plane inclined to the (111) free surface, which leads to the sharp drop of the penetration force observed in Figure 2.