Thus, the sensitivity can be obtained by the slope (ΔReflectance (%)/ΔConcentration (ng/ml)) of their respective linear relations. The slopes for the SPR responses of biotin in the WcBiM chip and the Au chip were 0.0052%/(ng/ml) and 0.0021%/(ng/ml), respectively. This shows that the sensitivity of the WcBiM chip was twice that of the Au chip. Thus, the experimental results showed that the WcBiM chip enhances sensitivity in the reflectance measurement mode. (1) Figure 7 Linearity in calibration

curves between SPR response and biotin concentration ranging from 50 to 200 ng/ml. The limit of detection (LOD) of this SPR sensor system was obtained using Equation 1 [26]. The standard deviation (SD) of the signal was recorded over 100 s in the stable state. The SDs of the blank measures for the WcBiM chip and the Au chip were 0.0026% and 0.0046%, respectively. Moreover, the SPR responses of 50 ng/ml biotin for both sensor GSK1120212 datasheet chips were 0.1360% and 0.0415%, respectively. Therefore, the LOD of the concentration (concentrationLOD) was calculated from Equation

1; the respective values were 2.87 ng/ml for the WcBiM chip and 16.63 ng/ml for the Au chip. Thus, the WcBiM chip can detect biomolecules at a very low level of concentration. From these results, if the Selleckchem BVD-523 SPR reflectance curve has a narrower FWHM and the detection mode is based on the intensity measurement, it is XAV939 expected that the sensitivity of the sensor system can be enhanced compared with the conventional device. In particular, for the early diagnosis of diseases through the detection of a disease-related biomarker with very low molecular weight or trace level concentration, the SPR sensor in the reflectance detection mode using the WcBiM chip will be very useful tool for medical applications. Conclusions The performance of a simplified SPR sensor with a WcBiM chip was investigated. Since the SPR sensor

was simple and miniaturized, the incident angle of the beam was fixed. Thus, the reflectance filipin curves for the designated incident angle were obtained by successive numerical fitting of the intensity profiles from 2D-CMOS for both WcBiM and Au chips. The FWHM of the Au chip was about twice as large as that of the WcBiM chip, which implied that the slope of the WcBiM reflectance curve was steeper. In order to achieve better performance, the reflectance was monitored at the specific pixel of the 2D-CMOS corresponding to the angle where the slope is the steepest in the reflectance curve. The slope was obtained by differentiating the reflectance curve with respect to the incident angle. The steepest slopes for the WcBiM chip and the Au chip were −237.52%/° and −115.92%/°, respectively. The WcBiM chip’s slope was about twice as steep as that of the Au chip. For the detection of a disease-related biomarker, it is necessary for biomolecules with very low molecular weight such as biotin to be detected.