Three different concentrations (200, 300 and 500 mg/L) of extracts were used to determine larvicidal and consequent effects on adult emergence. Larvicidal activities against A. aegypti have been determined in the different solvent leaf extracts of B. sensitivum. Results show that acetone extract had a dose-dependent effect and produced higher mortality (LC50 = 21.79 and LC99 = 139.50 mu g/ml) in larvae. Pupicidal activities of acetone extract showed the highest effect (LC50 selleck = 13.05 and LC99 = 137.75 mu g/ml). Acetone extracts also interfered with the normal development of adult mosquitoes (LC50 = 9.77
and LC99 = 11.83 mu g/ml). The study shows that acetone extracts of B. sensitivum is effective in controlling the Aedes aegypti larvae.”
“Photo-reactive nanogels with an integrated
photoinitiator-based functionality ICG-001 manufacturer were synthesized via a Reversible Addition-Fragmentation chain Transfer (RAFT) process. Without additional free initiators, these nanogels are capable of radical generation and initiating polymerization of a secondary monomer (i.e. dimethacrylate) that infiltrates and disperses the nanogel particles. Due to the presence of a RAFT functionality and the fact that all initiating sites are initially located within the nanogel structure, gelation can be delayed by sequencing the polymerization from the nanogel to the bulk matrix. During polymerization of a nanogel-filled resin system, a progressive delay of gelation conversion from about 2% for conventional chain growth polymerization to 18% for the same monomer containing 20 wt% nanogel additive was achieved. A significant delay of stress development was also observed with much lower final stress achieved with the nanogel-modified systems due to the change in network formation mechanics. Compared with the nanogel-free dimethacrylate control, which contained a uniformly distributed free initiator, the flexural modulus and mechanical strength results were maintained for the photopolymers
with MS-275 cell line nanogel contents greater than 10 wt%. There appears to be a critical interparticle spacing for the photo-reactive nanogel that provides effective photopolymerization while providing delayed gelation and substantial stress reduction.”
“Moisture-dependent physical grain properties of a new registered common bean cultivar ‘Kantar-05′ were determined. Some important chemical parameters of the grain were also investigated. The average length, width and thickness of the grain were 12.48, 7.92 and 5.00 mm at 7.82% db (dry basis) moisture content. The values of bulk density and true density of the grains decreased from 793.37 to 683.62 kg/m(3) (P<0.01) and from 1269.37 to 1206.55 kg/m(3) (P<0.05) with increasing moisture content. The coefficients of dynamic friction increased from 0.180 to 0.316, 0.173 to 0.276, and 0.226 to 0.331 on steel, plywood and wood friction surface, respectively with increasing moisture content. The force of rupture decreased from 121.88 to 68.